10 GAL KIT POLYASPARTIC 85
CLEARLIGHT GRAY - $30.00MEDIUM GRAY - $30.00DARK GRAY - $30.00BLACK - $30.00WHITE - $30.00BEIGE - $30.00TAN - $30.00MOCHA - $30.00SAFETY BLUE - $50.00SAFETY GREEN - $50.00SAFETY YELLOW - $50.00TILE RED - $30.00
10 GAL KIT
Health Care facilities
Car wash facilities
High Gloss & Build
4x more abrasion resistant than epoxy
Easy mixing ratio (1:1)
Cure at temparatures just above Freezing
Before coating is applied, concrete must be:
Dry – No wet areas
Clean – Contaminants removed
Profiled – Surface etched
Sound – All cracks and spalled areas repaired
Note: Mechanical preparation is the preferred method of preparing concrete for coating application. Shot-blasting, diamond grinding, scarifying and scabbling are all acceptable methods.
Voids, cracks, and imperfections will be seen in finished coating if the concrete is not patched correctly. Patch concrete with E2U Patch. After the patching material is cured diamond grind patch. If another patching material is used, contact an E2U technical representative for a compatible and approved alternative
All surfaces are not the same. It is recommended that a sample area be done before the start of the project. The test should be done on-site, using the proposed method by the assigned applicator to ensure proper adhesion and color. A sample area should also be done on any existing coatings to determine if any contaminants exist or if delaminating will occur.
While in an un-reacted state, may be cleaned up with water and degreaser. Isopropyl alcohol or acetone may be needed once the resin begins hardening. Lastly, a strong solvent like methylene chloride may be required if the resin is nearly set up.
The ratio of Polyaspartic 85 is 1 to 1. 1 part A (resin) to 1 part B (hardener). Generally, one mixed gallon is ideal for application. Mix the following with a stir stick. Note: If using a drill mixer, use a low speed to prevent air entrapment
Mix for 1 full minute using a slow speed drill, scraping the bottom and sides of the mixing container. Mix only that amount which can be spread in 30 minutes.
**Do not store product in direct sunlight
PHYSICAL PERFORMANCE PROPERTIES OF DRY FILM. All tests were conducted on 2.0 to 2.5 mil films, and air-dried for seven days at room temperature.
QUV WEATHEROMETER (ALCLAD ALUMINUM 1000 HRS.)
CHEMICAL RESISTANCE: 7-DAY SUBMERSION
Polyaspartic85 SDS - A
Polyaspartic85 SDS - B
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 25,000 square foot manufacturing facility in Fullerton, CA.