1.5 GAL KIT SATIN POLYASPARTIC (MATTE FINISH)
1.50 GAL KIT
Health Care facilities
Car wash facilities
Matte (Satin) Finish
Non-yellowing, UV stability
Chemical & Stain resistant
0 VOC, Low odor
No Hot-tire pickup
Fast drying (4-6 hour cure)
Cure in cold-climate environments (-30ºF)
Before coating is applied, concrete must be:
Dry – No wet areas
Clean – Contaminants removed
Profiled – Surface etched
Sound – All cracks and spalled areas repaired
Mechanical preparation is the preferred method of preparing concrete for coat- ing application. Shot-blasting, diamond grinding, scarifying and scabbling are all acceptable methods
Voids, cracks and imperfections will be seen in finished coating if the concrete is not patched correctly. Patch concrete with E2U Patch. After the patching mate- rial is cured, diamond grind patch. If another patching material is used, contact a E2U technical representative for a compatible and approved alternative
All surfaces are not the same. It is recommended that a sample area be done before the start of the project. The test should be done on-site, using the pro- posed method by the assigned applicator to insure proper adhesion and color. A sample area should also be done on any existing coatings to determine if any contaminants exist or if delaminating will occur.
While in an un-reacted state, may be cleaned up with water and degreaser. Isopropyl alcohol or acetone may be needed once the resin begins hardening. Lastly, a strong solvent like methylene chloride may be required if resin is nearly set up.
The ratio of Satin Polyaspartic is 2 to 1. 2part A (resin) to 1 part B (hardener). Generally, one mixed gallon is ideal for application. Mix the following with a stir stick. Note: If using a drill mixer, use a low speed to prevent air entrapment
Pour out 1 gallon of Part A into a clean bucket.
Add 1/2 gallon of Part B and mix for 2 minutes.Do not store product in direct sunlight
PHYSICAL PERFORMANCE PROPERTIES OF DRY FILM
All tests were conducted on 2.0 to 2.5 mil films, and air-dried for seven days at room temperature.
QUV WEATHEROMETER (ALCLAD ALUMINUM 1000 HRS.)
CHEMICAL RESISTANCE: 7-DAY SUBMERSION
Satin Polyaspartic DataSheet
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 25,000 square foot manufacturing facility in Fullerton, CA.