1 GAL KIT QUICK PATCH EPOXY
E2U Quick Patch is ideal for repairs on small holes, imperfections, and cracks in concrete. The repair of active structural cracks cannot be guaranteed.
Made for easy application 1 to 1 mix ratio
Mechanically prepare the surface by sanding, grinding, or shot blasting. Remove dust and residue by vacuum or broom. Wipe surface with slightly dampened terry cloth towel to remove dust and residue. Before coating is applied concrete must be:
Dry – No wet areas
Clean – Contaminants removed
Profiled – Surface etched
Sound – All cracks and spalled areas patched
Remove any existing coatings.
Note: Mechanical preparation is the preferred method of preparing concrete for coating application. Shot-blasting, diamond grinding, scarifying and scab- bling are all acceptable methods.
The ratio of E2U Quick Patch is 1 to 1. Using separate devices, measure equal amounts from container A and container B. Place material on a 2’ X 2’ mixing board. Once measured, mix both components with a 6” putty knife until a uniform color has been reached. (1 min.) Do not mix more material than can be applied in 10 minutes.
Hairline cracks must be routed with a minimum 1/8” straight diamond blade and cut ½” deep. Make sure to remove any loose concrete and/or foreign material. Dust and debris should be brushed and vacuumed out of crack and off surrounding areas. For larger size cracks, consult with a Quest representative for more detailed instructions.
Apply E2U Quick Patch into the crack with a 6” putty knife, making sure to completely fill. Push material as far into the crack as possible. Feather the E2U Quick Patch at each side of the crack to reduce telegraphing through the finish product. E2U Quick Patch may require a second coat or diamond grinding at the edges after it has cured. If grinding is required, it is necessary to grind the feathered edge of the E2U Quick Patch down to bare concrete. If the grinding and feathering process is not done properly, highlights may telegraph through the new coating system.
QuickPatch SDS - A Side
Quickpatch SDS - B Side
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 25,000 square foot manufacturing facility in Fullerton, CA.