2 GAL KIT POLYASPARTIC 100
E2U Polyaspartic100 has no solvemtn. It has excellent resistance to a broad range of chemicals such as inorganic acids, alkalis, amines, salts and solvents. E2U Polyaspartic85's formula provides non-yellowing and long-term gloss retention for interior/exterior applications. It is the essential product when a project needs a fast turnaround, a highly UV resistance, low VOC and flexible system.
CLEARSAFETY BLUE - $20.00SAFETY YELLOW - $20.00TILE RED - $20.00LIGHT GRAY - $20.00MEDIUM GRAY - $20.00DARK GRAY - $20.00BLACK - $20.00WHITE - $20.00BEIGE - $20.00TAN - $20.00MOCHA - $20.00
2 GAL KIT
Health Care facilities
Car wash facilities
Chemical& Stain resistant
Easy mixing ratio (1:1)
Fast drying (4-6 hour cure)
Before coating is applied, concrete must be:
Dry – No wet areas
Clean – Contaminants removed
Profiled – Surface etched
Sound – All cracks and spalled areas repaired
Mechanical preparation is the preferred method of preparing concrete for coating application. Shot-blasting, diamond grinding, scarifying and scabbling are all acceptable methods
Voids, cracks, and imperfections will be seen in finished coating if the concrete is not patched correctly. Patch concrete with E2U Patch. After the patching material is cured, diamond grind patch. If another patching material is used, contact an E2U technical representative for a compatible and approved alternative
All surfaces are not the same. It is recommended that a sample area is done before the start of the project. The test should be done on-site, using the proposed method by the assigned applicator to ensure proper adhesion and color. A sample area should also be done on any existing coatings to determine if any contaminants exist or if delaminating will occur.
While in an un-reacted state, may be cleaned up with water and degreaser. Isopropyl alcohol or acetone may be needed once the resin begins hardening. Lastly, a strong solvent like methylene chloride may be required if the resin is nearly set up.
The ratio of Top Shelf Epoxy is 2 to 1. That is two parts A (resin) to one part B (hardener). Mix the following with a drill and mixing paddle. Note: If using a drill mixer, use a low speed (not to exceed 300 rpm) to prevent air entrapment.
Mix for 1 full minute using a slow speed drill, scraping the bottom and sides of the mixing container. Mix only that amount which can be spread in 30 minutes.
E2U Epoxy is designed to be immediately poured on the floor. Leaving mixed product in the container will greatly reduce pot life. Once poured out on the floor, 20-30 minutes of working time can generally be expected.
PHYSICAL PERFORMANCE PROPERTIES OF DRY FILM. All tests were conducted on 2.0 to 2.5 mil films, and air-dried for seven days at room temperature.
QUV WEATHEROMETER (ALCLAD ALUMINUM 1000 HRS.)
CHEMICAL RESISTANCE: 7-DAY SUBMERSION
DATASHEET & SDS
Polyaspartic100 Gloss DataSheet
Gloss SDS Part A
Gloss SDS Part B
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 25,000 square foot manufacturing facility in Fullerton, CA.