32 OZ METALLIC PIGMENT
PEARLSILVERTITANIUMGUNMETALOCEAN BLUEORANGE GOLDGREEN APPLECOPPERSKY BLUEGRAPEBRASSLILACFOREST GREENWINE REDCAMBRIDGE BLUECHESTNUTPINK MAGIC YELLOWVIOLETBRIGHT WHITEULTRA SPARKLE WHITEORANGE REDPURPLE
PRODUCT AND COMPANY IDENTIFICATION
SECTION 1 NOTES: This document is prepared pursuant to the OSHA Hazard Communication Standard (29 CFR 1910.1200). In addition, other substances not Hazardous per this OSHA Standard may be listed. Where proprietary ingredient shows, the identity may be made available as provided in this standard.
COMPOSITION/INFORMATION ON INGREDIENTS
• N/E — Not Established
• ALL ingredients are registered on TSCA
*Unless otherwise noted, all PEL and TLV Values are reported as 8 hour time weighted averages (TWA)
POTENTIAL HEALTH EFFECTS:
Before coating is applied, concrete must be:
• Dry – No wet areas
• Clean – Contaminants removed
• Profiled – Surface etched
• Sound – All cracks and spalled areas repaired
Note: Mechanical preparation is the preferred method of preparing concrete for coating application. Shot-blasting, diamond grinding, scarifying and scabbling are all acceptable methods.
Voids, cracks and imperfections will be seen in finished coating if the concrete is not patched correctly. Patch concrete with E2U Patch. After the patching material is cured, diamond grind patch. If another patching material is used, contact a E2U technical representative for a compatible and approved alternative.
All surfaces are not the same. It is recommended that a sample area be done before the start of the project. The test should be done on-site, using the proposed method by the assigned applicator to insure proper adhesion and color. A sample area should also be done on any existing coatings to determine if any contaminants exist or if delaminating will occur.
Metallic Epoxy Datasheet
Metallic Epoxy SDS - A
Metallic Epoxy SDS - B
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 25,000 square foot manufacturing facility in Fullerton, CA.