15 GAL KIT FLEX EPOXY
CLEARLIGHT GRAYDARK GRAYBLACKTANBEIGEMEDIUM GRAYMOCHAWHITESAFETY BLUE - $150.00SAFETY GREEN - $150.00SAFETY YELLOW - $150.00TILE RED - $150.00
15 GAL KIT
Before coating is applied, concrete must be:
• Dry – No wet areas
• Clean – Contaminants removed
• Profiled – Surface etched
• Sound – All cracks and spalled areas repaired
Note: Mechanical preparation is the preferred method of preparing concrete for coating application. Shot-blasting, diamond grinding, scarifying and scabbling are all acceptable methods.
Voids, cracks and imperfections will be seen in finished coating if the concrete is not patched correctly. Patch concrete with E2U Patch. After the patching material is cured, diamond grind patch. If another patching material is used, contact a E2U technical representative for a compatible and approved alternative.
All surfaces are not the same. It is recommended that a sample area be done before the start of the project. The test should be done on-site, using the proposed method by the assigned applicator to insure proper adhesion and color. A sample area should also be done on any existing coatings to determine if any contaminants exist or if delaminating will occur.
Flex Epoxy Datasheet
GALLERY & TRAINING VIDEO
Toll-Free: (855) EPOXY2U(855) 376-9928
Call: (714) 477-8700
The world premium floor coating made by Epoxy2U in the USA. We operate a 20,000 square foot manufacturing facility in Fullerton, CA.